Do you know, że… ?
In surface and hybrid modeling, we have an operation at our disposal Offset Surface.Odsunięcie takie może mieć wartość zero – wówczas mówimy o kopiowaniu ścian.
But most often we shift surfaces by a given value. As with the shell whether Surface thickening, the result of the operation is dependent on the offset value and the minimum radius of curvature. assuming, that there are inner and outer radii in the model, these rays will increase or decrease. When the limit value is exceeded, it follows samoprzecięcie – co skutkuje najczęściej błędem.
In such a case, the program will separate the areas that cannot be moved away by displaying them on the list. You can view them and delete them manually, or press the button Remove any damaged walls.
Only these will remain on the list, which can be offset in one operation.
attention.
If you offset surfaces by zero (that is, you copy surfaces) a mimo to program zgłasza problem – spróbuj innej metody.
Choose a command Knit surfaces and mark the same walls. This time there was no problem. Just remember, that all marked faces must be in contact with each other, otherwise it would not be possible to combine them.
